| Tool tips everyone should
remember
In
honor of May’s designation as National Hand Tool Safety Month, the
Hand Tools Institute offers you 30 safe hand tool practices. While
most of these rules are common sense, check how many you actually
abide by.
1)
Use each tool only for the job
it was designed to do.
2)
Discard damaged or abused
tools promptly.
3)
Buy several versions or sizes
of the same tool.
4)
Inspect for distortion, cracks, chips, wear or mushrooming.
5)
Keep all tools clean and in
working order.
6)
Be sure handles are fixed firmly to a tool’s working end.
7)
Be sure tools and work mate properly to avoid slippage.
8)
Handles are made for the tool; never use extensions.
9)Confine
impact forces to striking and struck tools.
10)
Hold work in a clamp or vise,
not in your hand.
11)
Start off slowly when engaging the tool and the work.
12)
Shut current off before using
a tool near electricity.
Don’t
forget that tool box
HTI also offers hints for the safe and efficient use of tool
boxes and chests:
• Lightly oil all moving parts such as drawers, trays and
hinges at regular intervals.
• Use graphite, not oil, on locks and padlocks.
• Touch up all rusted spots, paying particular attention to
the bottom of tool boxes.
• Line the bottom of drawers or trays with felt or scrap
carpeting to protect the tools. This applies especially to
drawers holding tools with sharp or cutting edges.
• Check the handle; is it firmly attached to the tool box?
• Sand or file down any sharp edges that may damage clothes
or fingers. Sharp edges or corners usually are caused by
dropping the tool box to the floor, instead of placing it down.
• Wipe all grease and moisture from tools before storing
them in the box or chest. |
13)
Make sure the handle sits securely in your hand.
14)
Keep moving parts lightly lubed; avoid lube leakage.
15)
Wear approved safety goggles when using hand tools.
16)
Keep hands away from
sharp edges.
17)
Pull, don’t push, a wrench
handle for more leverage.
18)
Position your body securely while working with the tool.
19)
Keep jaw teeth, cutters and blades sharp for better results.
20)
Keep the tool’s moving parts
properly cleaned and tightened.
21)
Use steady pressure on jaws and cutters; don’t rock the tool.
22)
Support long, overhanging work in a vise at the far end.
23)
Use pads in the jaws to
protect soft or crushable work.
24)
Use a tool close to the vise
or clamp.
25)
Hold work in a clamp or vise with sufficient pressure.
26)
Keep clamped assemblies away from vibration and bumping.
27)
Discard a tool instead of
repairing it by welding or brazing.
28)
Keep tools from excessive heat.
29)
For continuous work, use
comfort grips or gloves.
30)
Follow instructions on the tool and/or package.
This article appeared in the April/May
2002 issue of
MRO
Today magazine. Copyright 2002.
Back to top
Back to Editorials archives
|
